There are any number of reasons to add an external fuel pump. The obvious choice here is to replace a mechanical pump either to eliminate a bad pump or to accommodate an upgraded fuel system. This is a guide to adding an external electric pump.
There are a wide variety of choices out there but the list is shorter when ease of installation and finding a pump are added into the mix. I will cover a few of options here. As a small side note it appears that there are only two primary manufacturers of aftermarket replacement fuel pumps here in the states, Walbro and Siemens. You will see them in a variety of labels and colors. The pumps that Ford uses are apparently made by Bosch.
Master E2000 / E2182 / NAPA TFP2P74028 / Carter P74028 This is the replacement unit for the external high pressure pump found on most 83-86 Fords with CFI. Also used on 86-91 Ford Aerostar, Bronco, Ranger, E150 to E350, F350/450. This pump is a good all around pump that can put out up to 95 PSI and 30/40 GPH. Pretty complete and easy to mount. E2000 has Ford quick disconnects and cost around $80.00 / E2182 has barbed fittings and cost around $75.00
NOTE: An important installation note on this pump. This is NOT a self-priming pump! It must be gravity or pressure fed to live. This pump is actually the high pressure pump that is fed by a low pressure tank pump. Used on a lot of 4×4 vehicle upgrades but always with a note about priming and installation.
Carter P5001 / NAPA P5001 / Holley HLY-12-927 This is a self priming pump. It regulates out 9-22psi.
Walbro FRA-1 This is a good low pressure pump for carburetor applications. Capable of 20 GPH at 4.5 – 7.0 PSI and a low current draw of about 2 AMPS.
Master E8248 – Universal 60 gph and 125 psi max.
Master E8012S – Universal pump 6 PSI has inverted flare fitting on both ends. About $45.00.
Master E8228 is a high pressure fuel pump capable of 90 psi pressure that has been designed to be used in retrofit situations. It comes with a mounting bracket and 5/16" fuel line barbs.
Master E8094 is a medium pressure fuel pump made for the GM throttle bodies which run at 15 psi.
Installation Tip – Any time you install an electric pump it is highly recommended to install an impact/inertia shutoff relay. It will shut down the pump if you are hit in an accident. All current cars have them and it is a very commonly overlooked and/or ignored safety feature. The BWD S9300 is a great piece. About $85.
Installation Tip – The easiest way to keep and / or add an electric pump to a carburetor system is to plumb it with a T fitting on the main feed from the tank and in the tank return leg put in a Kinsler 8 pound pressure valve. The outlet of the T would simply hook to the inlet of the carb.